UFR 2-10 Evaluation
Evaluation
A detailed comparison of the LES with the test case experiment is provided in Palau-Salvador et al (2010) and here only the main findings are reproduced. Fig. 5 shows contours of the mean streamwise velocity together with streamlines in the centre plane for both the shorter and the longer cylinder. Near the cylinder walls, LDV measurements could not be carried out so that there is a blanked out region in the experimental part of the figure. Overall, the contours of velocity and the streamlines show good agreement between LES and experiments, even though the length of recirculation behind the cylinder is slightly overpredicted for the long cylinder case. The core of the recirculation is located much closer to the cylinder in the long cylinder case and could not be resolved in the experiment. A more direct quantitative comparison of results is provided below in terms of profiles in Figures 8 – 10. Fig. 6 compares contours of the streamwise and vertical fluctuations in the longitudinal centre plane for both cases. The main features are again predicted quite well, at least qualitatively (for quantitative comparison see Figs. 8 and 9) and this includes the differences between the two cases and between streamwise and vertical fluctuations.
Fig. 7 provides contours of streamwise velocity and steamlines in two wall-parallel planes,
one near the mid-height of the cylinder (z/h = 0.6) and the other near the free-end
(z/h = 0.8).
Unfortunately, measurements closer to the ground plate are not available. Near mid-height,
the streamlines show the typical picture of the flow around a circular cylinder. As could be
imagined from the shape of the reverse flow region in Fig. 5, the separation bubble length
reduces significantly with distance from the ground and at
z/h = 0.6 it is already considerably
smaller than the reattachment length. Near the free-end (z/h = 0.8) a fairly clear bubble still
exists for the long cylinder case, but the bubble length is reduced even more. The effects of
the free-end are clearly present already and they are much stronger for the short cylinder case.
Here the end effects distort the bubble in the horizontal plane and make it much smaller. All
these features are predicted by the LES in fairly good agreement with the experiments.
Contributed by: Guillermo Palau-Salvador, Wolfgang Rodi, — Universidad Politecnica de Valencia, Karlsruhe Institute of Technology
© copyright ERCOFTAC 2011